Elevator: Hinged control surface located at the trailing edge of the horizontal stabilizer, which provides control of the airplane about the pitch axis and causes the airplane to climb or dive. The correct direction of control is to pull the transmitter elevator control stick back, toward the bottom of the transmitter, to move the elevator upward, which causes the airplane to climb, and vice versa to dive.
Subscribe to:
Post Comments (Atom)
Categories
- Battery (5)
- Cars (3)
- Engine (5)
- Heli (2)
- Rc Dictionary (44)
- Rc-Helicopter (2)
- Trucks (2)
Popular Posts
-
Image: Dihedral Dihedral: The V-shaped bend in the wing. Typically, more dihedral causes more aerodynamic stability in an airplane, ...
-
A 2.4GHz radio system which selects one (or two) of the available " free " frequencies and transmits only on the one(s) chosen....
-
A hand-held stick used to "flip start" a model airplane engine . The Hobbico Safe Start " chicken stick " is a saf...
-
Flutter: A phenomenon whereby the elevator or aileron control surface begins to oscillate violently in flight . This can sometimes cause th...
-
Flight Box : A special box used to hold and transport all equipment used at the flying field. Flight Box
-
Hinged control surfaces located on the trailing edge of the wing, one on each side, which provide control of the airplane about the rol...
-
CG (" Center of Gravity "): For modeling purposes, this is usually considered -- the point at which the airplane balances fore t...
-
The tendency of an airplane to yaw in the opposite direction of the roll. For instance, when right aileron is applied, the airplane yaws t...
-
This radio feature permits you to check servo operation without broadcasting a radio signal. A cable connects the transmitter to the receiv...
-
The angle that the wing penetrates the air. As the angle of attack increases so does lift and drag , up to a point .
0 comments:
Post a Comment